Features & Applications:
The RWS incorporates two of Tramex's well-known moisture scanners, the Leak
Seeker for Roofing, and the Wet Wall Detector for EIFS, incorporating all
the benefits and features of both these time proven instruments into this one instrument.
The Tramex RWS has
dual operating modes for EIFS and Roofing. Each of these modes has 2 ranges of
sensitivity for both deep and low penetration sensitivity, enabling the scanning
of Roofing, and EIFS, with a signal penetration ranging from the surface up to
approximately 4” (100mm).
Features:
- For tracing leaks into the waterproofing membrane back to the source
- Fast and easy to operate
- Instant clear readings
- “Hold” function facilitates ease of recording readings
- Lightweight hand held and battery operated
Applications:
Multi-mode moisture scanner for non-destructive moisture detection and leak
tracing in the building envelope including:
- Built-Up
- Non-Conductive Single Ply
- Modified and Foamed Roofing Systems
- Exterior Insulation and Finishing Systems (EIFS)
Spec Summary:
|
Dimensions: |
4.75”x 11” x
3”/125mm x 275mm x 75mm |
|
Weight: |
1.8kg (4lbs) |
|
Power Supply: |
One 9 volt battery |
|
Sensitivity: |
Four ranges:
EIFS Mode with high and low sensitivity.
Roofing Mode with high and low sensitivity. |
|
Accessories: |
Leather carrying case.
Telescopic
handle for use on roofing only. |
|
Limitations: |
Roofing: EPDM, Butyl rubber
roofing and
other conductive roofing.
EIFS: Hard Coat Stucco, wire lath or
wire mesh reinforced finishes. |
Tramex Roof & Wall Moisture Scanner
