Magnetic Locator Mode, Only the receiver is required when operating in the magnetic locator mode. Just set the Mode switch to MAG, the Gain control to mid-range, and you're ready to use the magnetic locator to locate underground ferrous pipes, water meters, water valves, and property markers - or anything that has a magnetic field including the 50/60Hz electro-magnetic field generated by energized power lines

Transmitter Inductive Mode Induction is achieved by placing the transmitter over the target cable/pipe or by using the optional Inductive Signal Clamp. The trace signal generates an alternating magnetic field around the cable, which induces a signal into the receiver's cable sensor. A sharp null in the audio signal between the two peaks occurs when the receiver's tip is directly over the cable.

Transmitter Conductive Mode If an exposed section of a target gas or water pipe is accessible, conductive coupling is the most reliable method for applying the trace signal. Providing a good electrical contact between the clip and the conductive portion of the target line by removing rust or paint before attaching the clip is very important.

Features:

• Two active frequencies for pipe, cable locator and line tracing
• Power line detection warning
• Inductive and conductive signal coupling
• Extra Heavy Duty Clips and Cable
• Five discrete sensitivity settings
• Audio Tone
• Water-resistant housing permits use in the rain
• Patented HeliFlux® Sensors

• Underground Cable Locator
• Surveyors' marker stakes
• Valve boxes
• cast iron pipe joints
• manhole covers

Spec Summary: