The RWS incorporates two of Tramex's well-known moisture scanners, the Leak Seeker for Roofing, and the Wet Wall Detector for EIFS, incorporating all the benefits and features of both these time proven instruments into this one instrument.

The Tramex RWS has dual operating modes for EIFS and Roofing. Each of these modes has 2 ranges of sensitivity for both deep and low penetration sensitivity, enabling the scanning of Roofing, and EIFS, with a signal penetration ranging from the surface up to approximately 4” (100mm).

Features:

• For tracing leaks into the waterproofing membrane back to the source
• Fast and easy to operate
• Instant clear readings
• “Hold” function facilitates ease of recording readings
• Lightweight hand held and battery operated

Applications:

Multi-mode moisture scanner for non-destructive moisture detection and leak tracing in the building envelope including:

• Built-Up
• Non-Conductive Single Ply
• Modified and Foamed Roofing Systems
• Exterior Insulation and Finishing Systems (EIFS)

Spec Summary:

Dimensions:	4.75”x 11” x 3”/125mm x 275mm x 75mm
Weight:	1.8kg (4lbs)
Power Supply:	One 9 volt battery
Sensitivity:	Four ranges: EIFS Mode with high and low sensitivity. Roofing Mode with high and low sensitivity.
Accessories:	Leather carrying case. Telescopic handle for use on roofing only.
Limitations:	Roofing: EPDM, Butyl rubber roofing and other conductive roofing. EIFS: Hard Coat Stucco, wire lath or wire mesh reinforced finishes.